qn —
Ethernet driver for Fujitsu MB86950 based boards
The qn interface provides access to the 10 Mb/s Ethernet
network via the Fujitsu MB86950 Ethernet chip set.
Each of the host's network addresses is specified at boot time
with an SIOCSIFADDR
ioctl(2). The
qn interface employs the address resolution protocol
described in arp(4) to
dynamically map between Internet and Ethernet addresses on the local
network.
The qn interface supports the following Zorro II
expansion cards:
- QuickNet
- Resource Management Force's Ethernet card, manufacturer 2011,
product 2
Multicasting not done yet. If the driver happens to lock up, you may use
ifconfig(8) to force the
driver down and up again. This usually helps.
The qn interface first appeared in
NetBSD 1.1